The conformity test made by HAMEG is based on the actual generic- and product stan- dards.In cases where different limit values are applicable, HAMEG applies the severer standard.For emission the limits for residential, commercial and light industry are applied.
Then the handle locking knobs must be simultaneously pulled outwards and STOP rotated to the required position. In case of complaints please contact the dealer who supplied your HAMEG product. The measuring circuits are considered not connected to the mains if a suitable isolation transformer ful. With the above listed exceptions HAMEG 10:1 probes can be used for DC measurements up to 600V or AC voltages (with a mean value of zero volt) of 1200Vpp. The probes (therefore good pulse transmission performance) the following mentioned have a HF-calibration in addition to low frequency numerical relationship between rise time tr (in ns) and bandwidth calibration adjustment. Two identical probes should be used for two oscilloscope amplifiers of the HM303-6 in the X-Y both vertical inputs. In order to avoid ground loops, use a mode can exceed an angle of 3. Again the correct slope setting is critical, because the external trigger signal may not have the same polarity or pulse edge as the test signal. This can be The internal triggering is disconnected by depressing the TRIG. The angle of slope The HM303-6 has a built-in electronic Component Tester is determined by the resistance of the resistor under test. The test pattern displays vary according to the component type as shown in the figures These transistor test patterns are valid in most cases, but below. This is caused by a shunt connection of real or complex impedances - especially if they are of relatively low impedance at 50Hz - to the component under test, often results differ greatly when compared with single components. SLOPE rising edge; (pushbutton LED) LED indicates operating (pushbutton switch) falling edge. LED lights, if sweep is triggered. Remove all signal connections to HM303-6 (cable, probe), release X-MAG.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |